Using ireal pro and preamp

  1. #1 by Nick Cheetham on 11-01-2018
    Nick Cheetham's Avatar
    Posts: 2

    Using ireal pro and preamp

    This may be a rookie question - I am using amplification for the first time as a violinist. I have a prodipe condenser microphone plugged via xlr into my mic500usb preamp. Output then goes to a Marshall guitar amp.

    I am used to using ireal pro to provide backing tracks - run from my iPad.

    Here is my question: is there a way to play my iPad input into the mic500usb as well as using the xlr input so that both the backing track and my instrument are output through the Marshall amp? The obvious route would be to use both the xlr and conventional jack inputs but the user manual says not to do this.

    Suggestions welcome please.
  2. #2 by Paul Vannatto on 11-01-2018
    Paul Vannatto's Avatar
    Posts: 10,870
    Hi Nick,

    Welcome to the forum. Unfortunately that is not possible with the mic500usb alone. Please refer to page 24 of the QSG, specifically points 14, 15 and the warning after 15. This unit is meant to input one source at any one time. You would need to get a small mixer, such as the Behringer 802 to combine your violin (using the mic500usb) and backing tracks from your iPad.

    __________________________________________________ _______________________
    For additional help please refer to the X32 wiki pages for updated and current documentation about the X32.

    For official technical and warranty support for your product you should contact the support team through their CARE department. You can contact CARE by phone at (+1) 702-800-8290 for the US and Canada and (+44) 1562 732290 in Europe.

    You can also contact CARE via email at CARECREA@musictribe.com. They strive to respond to emails within 24-48 hours during normal business hours, but please be patient if it takes longer due to the volume of emails they receive.


    Paul Vannatto
    Volunteer Forum Community Moderator
  3. #3 by Nick Cheetham on 11-01-2018
    Nick Cheetham's Avatar
    Posts: 2

    Thanks

    Thanks Paul and thanks for the welcome!

    It is as I thought - I will use my alternative - to put my iPad through a separate amp which will keep me going for now.

    Great response and rapid - thanks,

    Nick