mid/tops with sub crossover setup

  1. #1 by James Brough on 06-26-2018
    James Brough's Avatar
    Posts: 34

    mid/tops with sub crossover setup

    Hey folks
    I set up a crossover on x32 today, at first using the mono bus feeding the sub.
    I was surprised I had to use the matrices in the end (I linked two for mid/top and then used another for sub) so I could use the steeper filters.
    No problem, but just wondered if I missed something? I thought they might have included those filters on the main outs.
    Cheers
    J
  2. #2 by Craig Fowler on 06-26-2018
    Craig Fowler's Avatar
    Posts: 2,072
    The steeper filter options (Bessel, Buttersworth and Linkeitz-Riley) are all available on the LR and M buses... unless you were following an old video on youtube relating to old X32 firmware when they weren't...