Studio 50USB signal level

  1. #1 by Glenn Adams on 06-12-2017
    Glenn Adams's Avatar
    Posts: 2,272

    Studio 50USB signal level

    I have a pair of Studio 50USB's I use with a PC in my home. I've tried everything to lower the level from USB audio going to them. I am using them with a Windows 7 PC and all the level controls are almost bottomed and still have way too much level out of the speakers.

    Nothing on the speaker seems to lower it unless I use the analog inputs. I've been all over the sound drivers and nothing trims it down.

    "Sometimes it's the people who no one imagines anything of, who do the things that no one can imagine"
  2. #2 by Mark Edwards on 06-12-2018
    Mark Edwards's Avatar
    Posts: 1

    Yes, these speakers are WAY too loud on my iMac.

    I've been trying to get them quiet enough to use and finally had to switch to the analog outs from a small preamp. From there I had a knob to trim the volume before it went into the speakers.

    I have researched, but no luck finding a way to trim in preferences or through the terminal.

    I was hoping they would send out a firmware update, but nothing.