Firmware G3.4.1 is now available for PRO1, PRO2, PRO2C, and PRO X!

  1. #1 by Chase McKnight on 09-07-2016
    Chase McKnight's Avatar
    Posts: 357

    Firmware G3.4.1 is now available for PRO1, PRO2, PRO2C, and PRO X!

    G3.4.1 PRO1/2/2C/X

    Version G3.4.1 (01 September 2016)

    This document constitutes a formal release of PRO1/2/2C/X software for public usage.

    NEW FEATURES
    No new features - this is a bug fix release only

    ADDRESSED ISSUES
    • Neutron NB: Dante CM-1 persists internal configuration over power cycle
    • Neutron NB: Improved stability of CM-1 start-up in Neutron NB
    • Updater: Fixed redboot issue for TFTP update
    • Updater/DN9680: Improved stability of IO unit detection in updater app when updating units via DN9680 network
    • Groups: Right channel of Overlay Stereo Pairs in VCA/POP now selected by tapping channel
    button on Input bay as well as output bay
    • Effects: Fixed text display issue for Automixer when called in FX mode
    • Effects: Reverb M350 wet setting is now fully wet.
    • Effects: Resolved issue where Pitch Shifter could cause noise when used in conjunction
    with reverbs

    UPDATE PROCEDURE

    Update procedure for PRO X console From G3.2.x to G3.4.1 with new Neutron NB expansion module attached.

    N.B. Update of Neutron NB “IO Card” will require PRO X system to be on compatible build before NB module is recognised. This will mean that on the initial update from G3.2.6 or earlier the following steps will be required for a one off update.

    1. Download the “.tar” update fi le for your console
    2. Copy the file into “DL1Upgrades”, “DL2Upgrades” or “DL3Upgrades” for PRO1, PRO2/2C or PRO X respectively
    3. Run the Updater for G3.4.1 via USB as normal
    4. Update full PRO X system from G3.2.x to G3.4.1
    5. Power cycle system twice (as per-normal)
    6. Run G3.4.1 updater via USB again
    7. Update IO Card to G3.4.1
    8. Power cycle system twice

    From this point The Neutron NB expansion module (a.k.a “IO Card”) should be recognised by both the PRO X system and the PRO X updater app (USB updater).

    Once the system has reached this point the whole system, including the Neutron NB expansion module, can be updated in the regular way with only one pass of the updater application.

    Update procedure from G3.2..x or G3.4 to G3.4.1 for
    • PRO1
    • PRO2 and PRO2C
    • PRO X system WITHOUT Neutron NB installed
    • PRO X system WITH Neutron NB and G3.4 already installed

    Regular update procedure using USB stick
    1. Download the “.tar” update file for your console
    2. Copy the file into “DL1Upgrades”, “DL2Upgrades” or “DL3Upgrades” for PRO1, PRO2/2C or PRO X respectively
    3. Run the Updater for G3.4.1 via USB as normal
    4. Update full PRO X system from G3.2.x to G3.4.1
    5. Power cycle system twice (as per-normal)

    Chase McKnight
    Manager, Solutions
    MUSIC Group
    MIDAS